Brother International IntelliFax-3550 Service Manual - Page 92

3.6 Firmware Switch Setting and Printout [ A ] Firmware switch setting s Function The facsimile equipment incorporates the following firmware switch functions (WSW01 through WSW34) which may be activated with the procedures using the control panel keys and buttons. The firmware switches have been set at the factory in conformity to the communications standards and codes of each country. Do not disturb them unless necessary. Some firmware switches may not be applicable in some versions. The firmware switch data list indicates "Not used." for those inapplicable switches. WSW No. WSW01 WSW02 WSW03 WSW04 WSW05 WSW06 WSW07 WSW08 WSW09 WSW10 WSW11 WSW12 WSW13 WSW14 WSW15 WSW16 WSW17 WSW18 WSW19 WSW20 WSW21 WSW22 WSW23 WSW24 WSW25 WSW26 WSW27 WSW28 WSW29 WSW30 WSW31 WSW32 WSW33 WSW34 Firmware Switches (WSW01 through WSW34) Function Dial pulse setting Tone signal setting PABX mode setting TRANSFER facility setting 1st dial tone and busy tone detection PAUSE key setting and 2nd dial tone detection Dial tone setting 1 Dial tone setting 2 Protocol definition 1 Protocol definition 2 Busy tone setting Signal detection condition setting Modem setting AUTO ANS facility setting REDIAL facility setting Function setting 1 Function setting 2 Function setting 3 Transmission speed setting Overseas communications mode setting TAD setting 1 Communications setting 1 Communications setting 2 TAD setting 2 TAD setting 3 Function setting 4 Function setting 5 Function setting 6 Function setting 7 Function setting 8 Function setting 9 Function setting 10 Function setting 11 Function setting 12 Reference Page V-12 V-13 V-14 V-15 V-16 V-18 V-20 V-21 V-22 V-23 V-24 V-25 V-26 V-27 V-28 V-29 V-30 V-31 V-32 V-33 V-34 V-34 V-35 V-36 V-37 V-38 V-39 V-40 V-41 V-42 V-43 V-43 V-44 V-45 V - 10