Creative 70EM896106000 Owners Manual - Page 26

3 - PCIe Card & Interfaces The MicroDock Computer Speaker Analog Outputs These stereo mini-phone (3.5mm) jacks duplicate line level outputs 1-3 with a lower output level to accommodate consumer speakers. These line level outputs are designed to interface easily with powered speakers. Computer Speaker Output 1 L/R 2 L/R 3 L/R Duplicates Line Level Output Tip = 1L Ring = 1R Tip = 2L Ring = 2R Tip = 3L Ring = 3R MIDI 1 & 2 In/Outs MIDI input and output ports allow you to interface any type of MIDI equipment such as keyboards, effect units, drum or guitar controllers (anything with MIDI). The MIDI drivers were installed when you installed your PatchMix DSP software and the MIDI ports will appear in your system control panel under "Sounds and Audio Devices." There are two completely independent sets of MIDI input and output ports on the MicroDock, which can be assigned in your specific MIDI applications. Connect the MIDI breakout cable to the D-connector on the MicroDock. Connect MIDI Out to the MIDI In port of your synthesizer and MIDI Out of your synth to MIDI In of the MicroDock MIDI cable. EDI Connector (Card) Connects the MicroDock to the E-MU 1010 PCIe card using a CAT5-type computer cable. The cable supplied with the MicroDock is specially shielded to prevent unwanted RF emissions. Basic Connections MIDI Synthesizer MIDI In MIDI Out Out MIDI 1 In Turntable Audio from Synthesizer 1L In Out 1L Audio to Monitors ** 1R 2L 2R 1R 2L 2R Mixer & Speakers 2L Phono 2R Gnd MIDI Cable Out 1 2 3 3L 3R Connect Desktop Speakers to 1/8" jacks Stereo 48 VDC + - EDI AC Adapter 1010 PCIe Card Powered Desktop Speakers * NOTE: Line Inputs 2L/2R and Phono 2L/2R cannot be used at the same time. 26 Creative Professional