HP LaserJet Enterprise MFP M630 LaserJet Analog Fax Accessory 500 - Fax Guide - Page 61
Send-fax messages
View all HP LaserJet Enterprise MFP M630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Send-fax messages Table 2-1 Send-fax messages Message Error No. Cancelled 0 Success n/a Fail Busy 0 No Answer 0 Compression Error No Dial Modem Fail Communication Error Communication Error Any 0 Any 17 or 36 Any besides 17 or 36 Space Fail 0 Page Fail Memory Error Job Fail Power Failure No Fax Detected 0 0 Any 0 17 or 36 Description Action(s) Fax was cancelled by user at None. control panel of product. Fax sent successfully. None. The receiving fax machine is busy. The fax will be retired automatically (if configured), otherwise try resending fax later. The receiving fax machine is not answering the call. The receiving fax machine may be disconnected or turned off; contact the receiver to check the machine. Try resending. Fax may be corrupted or not Try resending fax. sent. No dial tone is detected when sending the fax. Verify the phone line is active; set the sending fax to "not" to detect a dial tone. Unexpected or bad response Try resending fax; if the error from the internal fax modem persists, contact service. to product. Lost telephone connection between sender and receiver. Try resending the fax. General communications issue where the fax transmission was interrupted or did not proceed as expected. Try resending fax; if the error persists, contact service. Unable to read or write the fax image file to disk; could be corrupt product disk or no space available on the product's disk. Try resending fax; if the error persists, contact service. Incompatible page width, or page had too many bad lines. Try resending fax; if the error persists, contact service. Out of RAM memory on product. If error persists, may need to add RAM to product. Fax failure; the fax job did not complete. Try resending fax; if the error persists, contact service. A power failure occurred during the fax transmission on the sending fax product. Try resending the fax. No fax machine was detected at receiving end. Verify fax number and have receiver verify fax machine is on and connected; then try resending fax. ENWW Solve fax problems 49