HP t505 Administrator Guide 7 - Page 148
root > Network continued, root/Network/VPN/VPNC/Group
View all HP t505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Table E-16 root > Network (continued) Registry key root/Network/VPN/AutoStart root/Network/VPN/PPTP/Domain root/Network/VPN/PPTP/Gateway root/Network/VPN/PPTP/Password root/Network/VPN/PPTP/Username root/Network/VPN/Type root/Network/VPN/VPNC/Domain root/Network/VPN/VPNC/Gateway root/Network/VPN/VPNC/Group root/Network/VPN/VPNC/GroupPassword root/Network/VPN/VPNC/IKEDHGroup root/Network/VPN/VPNC/LocalUDPPort root/Network/VPN/VPNC/NATTMode root/Network/VPN/VPNC/Password root/Network/VPN/VPNC/PerfectForwardSecrecy root/Network/VPN/VPNC/Security root/Network/VPN/VPNC/Username root/Network/Wired/DefaultGateway root/Network/Wired/EnableDefGatewayAsDNS root/Network/Wired/EthernetSpeed root/Network/Wired/IPAddress root/Network/Wired/IPv6Enable root/Network/Wired/Interface root/Network/Wired/MTU Description mydomain.com will allow the server definition myserver to resolve properly to myserver.mydomain.com, even if the DNS server does not have myserver in its name resolution tables. Up to five additional search domains can be specified. If set to 1, VPN starts automatically when the system starts up. Sets the PPTP domain. Sets the PPTP gateway. Sets the PPTP user password. Sets the PPTP username. Sets the VPN type. Sets the VPNC domain. Sets the VPNC gateway. Sets the VPNC group. Sets the VPNC group password. Sets the VPNC IKE Diffie-Hellman group. Sets the local UDP port to use for VPNC. If set to 0, a random port will be used. This setting is valid only when the NAT traversal mode (NATTMode) is cisco-udp. Sets the VPNC NAT traversal mode. Sets the VPNC user password. Sets the VPNC Diffie-Hellman group to use for Perfect Forward Secrecy (PFS). Sets the VPNC security level. Sets the VPNC username. Sets the default gateway the device will use to communicate with the Internet. Typically this is the IP address of the router. This setting will only take effect when Method is set to Static. If set to 1, the default gateway will also be the name server. Sets the link speed of the primary Ethernet network interface. Automatic allows the fastest available link speed to be used, which is usually 1 Gbps or 100 Mbps/Full depending on the switch. The link speed can also be forced to a single speed (100 Mbps or 10 Mbps) and duplex mode (Full or Half) to support switches and hubs that do not perform appropriate auto-negotiation. Sets the IPv4 address of the thin client. This setting will only take effect when Method is set to Static. If set to 1, IPv6 is enabled. Sets the default Ethernet interface or NIC. Sets the MTU. It does not matter if the IP address is static or DHCP-acquired. 136 Appendix E Registry keys