IBM 8862 Hardware Maintenance Manual - Page 43
PCI-X, adapters
UPC - 000435172679
View all IBM 8862 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
PCI or PCI-X adapters The following notes describe the types of adapters that your server supports and other information that you must consider when installing a PCI or PCI-X adapter: v The server supports 3.3 V and universal PCI and PCI-X adapters; it does not support 5.0-V-only adapters. v The following illustration shows the location and bus speeds of the PCI-X expansion slots on the I/O board. Note: The illustrations in this document might differ slightly from your hardware. Attention LED Power LED PCI slot 1 33 MHz 64-bit PCI-X slot 2 100 MHz 64-bit PCI-X slot 3 133 MHz 64-bit PCI-X slot 4 133 MHz 64-bit PCI-X slot 5 133 MHz 64-bit PCI-X slot 6 133 MHz 64-bit SCSI internal cable connector (J17) v Each PCI/PCI-X slot is on a separate PCI bus. Slot number 1 2 3 4 5 6 PCI Bus 0 3 6 F (15) C (12) 9 v Slot 1 is a PCI slot and is dedicated to the Remote Supervisor Adapter II. The adapter will operate in PCI mode only. The bus speed is 33 MHz only. The adapter is non-hot-swappable; turn off the server when removing and installing the adapter. v For slots 2 through 6, the bus speed will be set to the speed of the adapter; if a PCI adapter is installed, the bus will run in PCI mode. v If you install a ServeRAID 6i adapter, it must be installed in slot 2. v If you install an IXA adapter, it must be installed in slot 3. v Locate the documentation that comes with the adapter and follow those instructions in addition to the instructions in this chapter. Chapter 4. Installing options 33