IBM 8862 Hardware Maintenance Manual - Page 49
Memory, modules
UPC - 000435172679
View all IBM 8862 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Memory modules The following notes describe the types of dual inline memory modules (DIMMs) that your server supports and other information that you must consider when installing DIMMs: v Your server supports 2.5 V, 184-pin, error correcting code (ECC), double-data rate (DDR) SDRAM, PC2100 registered DIMMs with Chipkill memory protection. v DIMMs can be removed and replaced through the of the memory cassette. v You can increase the amount of memory in the server by replacing the DIMMs with higher-capacity DIMMs or installing additional pairs of DIMMs in open sockets. The server supports 512 MB, 1 GB, and 2 GB DIMMs. See the ServerProven® list at http://www.ibm.com/pc/compat/ for an updated list of memory modules supported by the server. v For a server with an 8-DIMM-connector memory cassette, you can increase the memory capabilities of your server by upgrading to the 16-connector memory cassette. The 16-connector memory cassette supports memory mirroring and Memory ProteXion. See the ServerProven list at http://www.ibm.com/pc/compat/ for a list of memory cassettes supported by the server. More information on Memory ProteXion and memory mirroring is available in the User's Guide on the xSeries Documentation CD. v The server uses interleaved DIMMs, which requires that you install DIMMs in specific configurations: - In the 8-DIMM-connector memory cassette, install DIMMs in pairs. Each pair must be of the same type, capacity, and speed. The DIMM connectors are arranged in two groups of four rows each; the server comes with one pair of DIMMs installed in DIMM connectors 1 and 5 in the memory cassette. - In the 16-DIMM memory cassette, the DIMM connectors are arranged in two groups of eight rows each. In non-mirrored mode, install DIMMs in pairs; in mirrored mode, install DIMMs in quads, or groups of 4. Each pair or quad must be of the same type, capacity, and speed. v You must populate the DIMM connectors in the following order with the largest size first: 8-DIMM memory board First pair Second pair Third pair Fourth pair DIMMs 1 and 5 DIMMs 2 and 6 DIMMs 3 and 7 DIMMs 4 and 8 16-DIMM memory board in non-mirrored mode First pair Second pair Third pair Fourth pair Fifth pair Sixth pair Seventh pair Eighth pair DIMMs 1 and 3 DIMMs 14 and 16 DIMMs 2 and 4 DIMMs 13 and 15 DIMMs 5 and 7 DIMMs 10 and 12 DIMMs 6 and 8 DIMMs 9 and 11 Chapter 4. Installing options 39