Kyocera FS-1128MFP Service Manual - Page 140

2JN (2) Table of general classification Error code U00000 U00100 U00200 U00300 U004XX U00500 U006XX U00700 U008XX U009XX U010XX U011XX U01400 U01500 U01600 U017XX U018XX U02000 U02100 U02200 U023XX U02400 U03000 U03100 U03200 U03300 Description No response or busy after the set number of redials. Transmission was interrupted by a press of the stop/clear key. Reception was interrupted by a press of the stop/clear key. Recording paper on the destination unit has run out during transmission. A connection was made but interrupted during handshake with the receiver unit (refer to page 1-424 U004XX error code table). Multiple communication was interrupted and call was not made on destination units after interruption. Communication was interrupted because of a machine problem (refer to page 1-4-25 U006XX error code table). Communication was interrupted because of a problem in the destination unit. A page transmission error occurred in G3 mode (refer to page 1-4-25 U008XX error code table). A page reception error occurred in G3 mode (refer to page 1-4-25 U009XX error code table). Transmission in G3 mode was interrupted by a signal error (refer to page 1-4-26 U010XX error code table). Reception in G3 mode was interrupted by a signal error (refer to page 1-4-28 U011XX error code table). An invalid one-touch key was specified during communication. A communication error occurred when calling in V.8 mode. A communication error occurred when called in V.8 mode. A communication error occurred before starting T.30 protocol during transmission in V.34 mode (refer to page 1-4-30 U017XX error code table). A communication error occurred before starting T.30 protocol during reception in V.34 mode (refer to page 1-4-30 U018XX error code table). Relay broadcast was refused by a relay station because of a mismatch in permit ID number and permit telephone number when a relay command was issued. A relay command failed because the destination unit (relay station) had no relay broadcast capability. A relay command from a command station failed because a telephone number that was not registered in the relay station was specified. Or, relay broadcast was requested to a relay station but failed because a telephone number that was not registered in the relay station was specified. Or, Subaddress-based relay broadcast transmission failed because the data registered in the Subaddress relay box was deleted. Receiving station information was not normally received in reception of a relay command (refer to page 1-4-30 U023XX error code table). An interoffice subaddress-based relay transmission was interrupted because of a mismatch in the specified relay box number. No document was present in the destination unit when polling reception started. In reverse polling, although no original was set in the destination unit, transmission was complete. In confidential polling reception, data was not accumulated in the specified box in the destination unit. Or, in interoffice subaddress-based bulletin board reception, data was not stored in the box specified by the destination unit. In polling reception from a unit of our make, operation was interrupted due to a mismatch in permit ID or telephone number. Or, in interoffice subaddress-based bulletin board reception, operation was interrupted due to a mismatch in permit ID or telephone number. 1-4-22