Kyocera FS-1128MFP Service Manual - Page 207
Requirements on PWB Replacement, 1-6-1 Upgrading the firmware, About 40 seconds later - firmware update
View all Kyocera FS-1128MFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 207 highlights
2JN 1-6 Requirements on PWB Replacement 1-6-1 Upgrading the firmware Follow the procedure below to upgrade the firmware of control PWB (main controller and engine) and scanner PWB. Preparation Extract the file that has the download firmware and put them in the USB Memory. Procedure 1. Turn ON the main switch and confirm if the screen shows "Ready to print" then, turn OFF the main power switch. 2. Insert USB memory that has the firmware in the USB memory slot. 3. Turn ON the main power switch. 4. About 40 seconds later, "Firmware Update Downloading" will be displayed and blinking the memory LED (this shows to start the download). 5. Display the software that now upgrading (5 minutes). USB memory USB memory slot "Firmware Update Main" "Engine" "Scanner" 6. Display the completion of the upgrade (Memory LED is ON condition). Firmware Update Main: Completed Engine: Completed Scanner: Completed 7. Turn OFF the main power switch and remove the USB memory. Check the result of the version up 1. Output the service status by the U000 or execute U019 to check. Figure 1-6-1 1-6-1