Kyocera FS-1128MFP Service Manual - Page 87

2JN Maintenance item No. Description U641 Setting communication time 2 Description Sets the time-out time for fax transmission. Purpose To improve transmission performance for international communications mainly. Start 1. Press the start key. 2. Select the item to be set using the cursor up/down keys. Display Description T0 TIME OUT Sets the T0 time-out time. T1 TIME OUT Sets the T1 time-out time. T2 TIME OUT Sets the T2 time-out time. Ta TIME OUT Sets the Ta time-out time. Tb1 TIME OUT Sets the Tb1 time-out time. Tb2 TIME OUT Sets the Tb2 time-out time. Tc TIME OUT Sets the Tc time-out time. Td TIME OUT Sets the Td time-out time. Setting the T0 time-out time Sets the time before detecting a CED or DIS signal after a dialing signal is sent. Depending on the quality of the exchange, or when the auto select function is selected at the destination unit, a line can be disconnected. Change the setting to prevent this problem. 1. Change the setting using the cursor left/right keys. Description Setting range Initial setting T0 time-out time 30 to 90 s 56 2. Press the start key. The value is set. Setting the T1 time-out time Sets the time before receiving the correct signal after call reception. No change is necessary for this maintenance item. 1. Change the setting using the cursor left/right keys. Description Setting range Initial setting T1 time-out time 30 to 90 s 36 2. Press the start key. The value is set. 3. To return to the screen for selecting an item, press the stop/clear key. Setting the T2 time-out time The T2 time-out time decides the following. From CFR signal output to image data reception From image data reception to the next signal reception In ECM, from RNR signal detection to the next signal reception 1. Change the setting using the cursor left/right keys. Description Setting range Initial setting T2 time-out time 1 to 255 69 2. Press the start key. The value is set. Change in value per step 100 ms 1-3-59