Kyocera FS-1128MFP Service Manual - Page 86
Setting the reference for RTN signal output, Setting communication time 1
View all Kyocera FS-1128MFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
2JN Maintenance item No. Description U633 (cont.) Setting the reference for RTN signal output Sets the error line rate as the reference for RTN signal output. If transmission errors occur frequently due to the quality of the line, they can be reduced by lowering this setting. 1. Select the setting using the cursor up/down keys. Display Description 5% Error line rate of 5% 10% Error line rate of 10% 15% Error line rate of 15% 20% Error line rate of 20% Initial setting: 15% 2. Press the start key. The setting is set. Completion Press the stop key. The screen for selecting a maintenance item No. is displayed. U634 Setting communication control 5 Description Sets the maximum number of error bytes judged acceptable when receiving a TCF signal. Used as a measure to ease transmission conditions if transmission errors occur. Method 1. Press the start key. 2. Change the setting using the cursor left/right keys or numeric keys. Description Setting range Initial setting Number of allowed error bytes when detecting TCF 0 to 255 0 U640 3. Press the start key. The value is set. Completion Press the stop key. The screen for selecting a maintenance item No. is displayed. Setting communication time 1 Description Sets the detection time when one-shot detection is selected for remote switching. (This setting item will be displayed, but the setting made is ineffective.) Sets the detection time when continuous detection is selected for remote switching. (This setting item will be displayed, but the setting made is ineffective.) Method 1. Press the start key. 2. Select the item to be set using the cursor up/down keys. Display Description Setting range Initial setting TIME (ONE) Sets the one-shot detection time for remote switching. 0 to 255 7 TIME (CONT) Sets the continuous detection time for remote 0 to 255 80 switching. 3. Change the setting using the cursor left/right keys or numeric keys. 4. Press the start key. The value is set. Completion Press the stop key. The screen for selecting a maintenance item No. is displayed. 1-3-58