Kyocera FS-1128MFP Service Manual - Page 64

2JN Maintenance item No. Description U244 Checking the DP sensors Description Displays the status of the respective sensors in the DP. Purpose To check if respective sensors in the DP operate correctly. Method 1. Press the start key. 2. Turn the respective sensors on and off manually to check the status. When a sensor is detected to be in the ON position, the display for that sensor will be highlighted. Display Sensors TMG SW DP timing sensor SET SW DP original sensor DP OP SW DP open/close sensor U250 Completion Press the stop key. The screen for selecting a maintenance item No. is displayed. Setting the maintenance cycle Description Displays and changes the maintenance cycle. Purpose To check and change the maintenance cycle. Method 1. Press the start key. The currently set maintenance cycle is displayed. Setting 1. Select [M.CNT A] using the cursor up/down keys. 2. Change the setting using the cursor left/right keys or numeric keys. Description Setting range Initial setting Maintenance cycle 0 to 9999999 100000 3. Press the start key. The value is set. Clearing 1. Select [CLEAR] using the cursor up/down keys. 2. Press the start key. The count is cleared. Completion Press the stop key. The screen for selecting a maintenance item No. is displayed. U251 Checking/clearing the maintenance count Description Displays, clears and changes the maintenance count. Purpose To check the maintenance count. Also to clear the count during maintenance service (replacing the maintenance kit). (See page 2-4-4, page 1-5-29 and page 1-5-30) Method 1. Press the start key. The maintenance count is displayed. Setting 1. Select [M.CNT A] using the cursor up/down keys. 2. Enter a count using the cursor left/right keys or numeric keys. 3. Press the start key. The count is set. Clearing 1. Select [CLEAR] using the cursor up/down keys. 2. Press the start key. The count is cleared. Completion Press the stop key. The screen for selecting a maintenance item No. is displayed. 1-3-36