Kyocera TASKalfa 4500i 3500i/4500i/5500i Operation Guide Rev-1 2011.4 - Page 305

Default Setting (System Menu) Paper Source for Cover Select the paper source for cover paper from Cassette 1-5 or Multi Purpose Tray. Covers are used for Booklet (see page 4-20) and Cover (see page 4-22) modes. NOTE: [Cassette 3] to [Cassette 5] are displayed when the following options are installed. [Cassette 3]: When a paper feeder (500-sheet x 2) or large capacity paper feeder (1500-sheet x 2) is installed [Cassette 4]: When a paper feeder (500-sheet x 2) or large capacity paper feeder (1,500-sheet x 2) is installed [Cassette 5]: When a side feeder (3,000-sheet) is installed Use the procedure below to select the paper source for the cover. 1 Press the System Menu key. 2 Press [Common Settings], [Next] of Original / Paper Settings, [ ] and then [Change] of Paper Source for Cover. 3 Select the paper source to load cover paper. 4 Press [OK]. Special Paper Action When printing on Prepunched, Preprint, and Letterhead, punch-holes might not be aligned or the print direction might be upside-down depending on how originals are set and the combination of copying functions. In such a case, select [Adjust Print Direction] to adjust the print direction. When paper orientation is not important, select [Speed Priority]. 9 The table below lists the available settings and their details. Item Adjust Print Direction Speed Priority Description Adjust print direction. Print speed is a little slower. Select this item to print on Prepunched, Preprint and Letterhead. Give the job speed top priority and disregard the paper orientation. Select this item when paper orientation is not important. 9-11