Sharp DX-C310FX DX-C310 DX-C3400 Operation Manual - Page 564

SYSTEM SETTINGS OPERATION PANEL (GENERAL) Fax Data Receive/Forward This section explains settings for reception and forwarding. Select the [Fax Data Receive/Forward] key and configure the settings. For explanations of settings related to the fax function, see "FAX SYSTEM SETTINGS ON THE OPERATION PANEL" (page 6-97). I-Fax Settings These settings can be configured when the Internet fax expansion kit is installed. Reception Start Select this key to immediately connect to your mail server (POP3 server) and check for received Internet faxes. If you have received Internet faxes, the faxes will be retrieved and printed. To use this function, POP3 server settings must be configured. Configure these settings in the screen that appears when [Application Settings] - [Internet Fax Settings] is selected in the Web page menu. Manual Reception Key in Initial Screen This displays the [I-Fax Manual Reception] key in the base screen of Internet fax mode. Forward Received Data When the machine cannot print because it is out of paper or out of toner, received faxes can be forwarded to another Internet fax machine. • To store a forwarding address, see "Set Address for Data Forwarding" (page 6-87) in the system settings (administrator) in the Web page menu. • If forwarding was not successful because the transmission was canceled or a communication error occurred, the faxes that were to be forwarded will return to the print queue on the machine. • If the initial pages of a fax were successfully printed, only those pages that were not printed will be forwarded. • Forwarding is not possible if no faxes were received or a forwarding address is not programmed. • If "Hold Setting for Received Data Print" (page 6-35) is enabled, you will be prompted to enter a password. Enter the correct password with the numeric keys. To cancel forwarding... Press the [JOB STATUS] key, and then cancel the forwarding job in the same way as a transmission job. USB-Device Check This lets you check the connection when a USB device is connected to the machine. Select the [USB-Device Check] key to check the connection. The status of a USB device that is not compatible with the machine will not appear. 6-16 Contents