Sharp DX-C310FX DX-C310 DX-C3400 Operation Manual - Page 620
Device Control
View all Sharp DX-C310FX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 620 highlights
SYSTEM SETTINGS WEB PAGE (ADMINISTRATOR) Device Control These settings control devices installed on the machine. Select [System Settings] - [Device Control] from the menu bar and configure each setting. AB/Inch Type Setting The numbers and units of the default settings and input ranges that appear in the setting screens can be switched between inches and AB sizes. Default Original Size Settings Specify this setting when a particular original size is frequently used. The setting will appear in the [Original] key. Specifying this setting allows the original size setting to be omitted. Mode Settings Copy None, A5, B5, A4, 216mm x 330mm (8-1/2" x 13"), 8-1/2" x 13-2/5" (216mm x 340mm), 216mm x 343mm (8-1/2" x 13-1/2"), 8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2", 16K Image Send None, A5, B5, A4, 216mm x 330mm (8-1/2" x 13"), 8-1/2" x 13-2/5" (216mm x 340mm), 216mm x 343mm (8-1/2" x 13-1/2"), 8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2", 16K, Long Size When [None] is selected, the original size does not appear and must always be set manually. Disabling of Document Feeder Use this setting to prohibit the use of the automatic document feeder, such as when the feeder malfunctions. (When the setting is enabled, scanning is still possible using the document glass.) Original Feeding Mode The following original feeding modes can be set to operate by default in copy, and image send modes. When a mode is frequently used, this saves you from having to select the mode in the special modes each time you need to use it. • Mixed size originals of the same width (Copy mode only) • Slow Scan Mode Disabling of Duplex This is used to disable two-sided printing, such as when the duplex module malfunctions. Disabling of Optional Paper Feed Unit (When a 500-sheet paper feed unit is installed.) This setting is used to disable a 500-sheet paper feed unit, such as when it malfunctions. Disabling of Tray Settings This setting is used to prohibit tray settings (except for the bypass tray). Disabling of Offset (When a finisher is installed.) This setting is used to disable the offset function. Disabling of Stapler (When a finisher is installed.) This setting is used to prohibit stapling, such as when the stapler unit of the finisher malfunctions. 6-72 Contents