Xerox 6180MFP User Guide - Page 219
Control Panel Error Messages, Phaser® 6180MFP Multifunction Printer, & Belt Unit - d firmware
UPC - 095205733839
View all Xerox 6180MFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 219 highlights
Control Panel Error Messages Message Limit Reached Press Set MCU Firmware Error 024-340 Restart Printer MCU NVRAM Error 041-340 Address: xxxx Data: xx Restart Printer Open Front Cover & Belt Unit Remove Paper Open Front Cover Remove Paper Open Front Cover Remove Paper & Check Paper Type Open Tray 2 Remove Paper Open & Close Door A Open Tray 3 Remove Paper Open & Close Door A Out of Memory Press Set Condition/Reason/Action The user has exceeded the limit on the number of pages that can be printed when using an authentication function. Contact the administrator. A firmware error has occurred. Restart the printer. If the problem persists, contact Xerox Technical Support. A NVRAM error has occurred. Restart the printer, and if the problem persists contact Xerox Technical Support. Paper is jammed inside the printer. Press the button to open the front cover and remove the jammed paper. See Paper Jams on page 10-2. Paper is jammed inside the printer. Press the button to open the front cover and remove the jammed paper. See Paper Jams on page 10-2. Paper is jammed inside the printer. Press the button to open the front cover and remove the jammed paper. Check the paper type. See Paper Jams on page 10-2. Paper is jammed inside Tray 2. Remove the jammed paper. Open and close the front cover. See Paper Jams on page 10-2. Paper is jammed inside Tray 3. Remove the jammed paper. Open and close the front cover. See Paper Jams on page 10-2. The printer memory is full and cannot continue processing the current print job. Press the OK button to clear the message, cancel the current print job, and conduct the next print job, if any. Press the Stop button to cancel the print job. Press the Forward Arrow button to open the Walk-Up Features menu and delete the job being held. if the problem has not been corrected, turn the printer off and then on again. To avoid this error in the future, do the following: ■ Delete unnecessary fonts, macros, and other data in printer memory. ■ Install additional printer memory. Phaser® 6180MFP Multifunction Printer 10-35