AMD AMD-K6-2/400 User Guide - Page 139
INIT (Initialization), Sampled, Pin Attribute, Summary
View all AMD AMD-K6-2/400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
23542A/0-September 2000 Preliminary Information AMD-K6™-2E+ Embedded Processor Data Sheet Sampled This signal is provided to allow the system logic to handle exceptions in a manner consistent with IBM-compatible PC/AT systems. The processor samples IGNNE # as a level-sensitive input on every clock edge. The system logic can drive the signal either synchronously or asynchronously. If it is asserted asynchronously, it must be asserted for a minimum pulse width of two clocks. 5.29 INIT (Initialization) Pin Attribute Summary Input The assertion of INIT causes the processor to empty its pipelines, to initialize most of its internal state, and to branch to address FFFF_FFF0h-the same instruction execution starting point used after RESET. Unlike RESET, the processor preserves the contents of its caches, the floating-point state, the MMX state, Model-Specific Registers, the CD and NW bits of the CR0 register, and other specific internal resources. Sampled INIT can be used as an accelerator for 80286 code that requires a reset to exit from Protected mode back to Real mode. INIT is sampled and latched as a rising edge-sensitive signal. INIT is sampled on every clock edge but is not recognized until the next instruction boundary. During an I/O write cycle, it must be sampled asserted a minimum of three clock edges before BRDY # is sampled asserted if it is to be recognized on the boundary between the I/O write instruction and the following instruction. s If INIT is asserted synchronously (see Table 19 on page 140), it can be asserted for a minimum of one clock. s If it is asserted asynchronously, it must have been negated for a minimum of two clocks, followed by an assertion of a minimum of two clocks. Chapter 5 Signal Descriptions 117