Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 105

Table 3-2, POST Error Messages, Error Code, Audible Beeps, Probable Source of Problem

Get Compaq ProLiant 8000 PDF manuals and user guides View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 105 highlights

3-8 Compaq ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maintenance and Service Guide Table 3-2 POST Error Messages Error Code A Correctable Memory Error occurred prior to this power-up A Critical Error occurred prior to this power-up Beeps only Audible Beeps None None 2 long Beeps only 2 long, 2 short Critical Fan Failure Detected - System Shutting Down System Halted ECC Multiple Bit Error Detected in DIMM: FATAL ROM ERROR: The System ROM is not properly programmed Initialization failure. Re-seat the processor and Processor Power Module before attempting replacement None None 1 long, 1 short None Probable Source of Problem A memory module has experienced an error which, while recoverable, has generated a predictive failure warning. A catastrophic system error, which caused the server to crash, has been logged. No valid memory is present in the system. The power has cycled because the temperature is too hot. The processor fan is not installed, or is not spinning. A critical fan is not spinning. Recommended Action Run Compaq Diagnostics to identify and replace the appropriate memory module. Run Diagnostics. Replace failed assembly as indicated. 1. If no memory modules are present, install at least one memory module to conform to minimum hardware configuration specifications. 2. Reseat all installed memory modules. 3. If the system contains more than one memory module, remove one module, and restart the server. Repeat as needed to isolate the bad memory module. Check fans. 1. Check fans. 2. Check fan cable connections. A memory module failure generated a multiple bit error that could not be corrected. The System ROM is not properly programmed. Processor was not fully seated. A processor internal failure occurred. Run Compaq Diagnostics and replace failed memory module as indicated. Flash the ROM as explained in the troubleshooting guide or call a Compaq authorized service provider. 1. Reseat the processor. 2. Replace the processor if the failure recurs. continued

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
3-8
Compaq ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maintenance and Service Guide
Table 3-2
POST Error Messages
Error Code
Audible Beeps
Probable Source of Problem
Recommended Action
A Correctable
Memory Error
occurred prior to this
power-up
None
A memory module has
experienced an error which,
while recoverable, has generated
a predictive failure warning.
Run Compaq Diagnostics to
identify and replace the
appropriate memory module.
A Critical Error
occurred prior to this
power-up
None
A catastrophic system error,
which caused the server to
crash, has been logged.
Run Diagnostics. Replace failed
assembly as indicated.
Beeps only
2 long
No valid memory is present in
the system.
1.
If no memory modules are
present, install at least one
memory module to
conform to minimum
hardware configuration
specifications.
2.
Reseat all installed
memory modules.
3.
If the system contains
more than one memory
module, remove one
module, and restart the
server. Repeat as needed
to isolate the bad memory
module.
Beeps only
2 long, 2 short
The power has cycled because
the temperature is too hot. The
processor fan is not installed, or
is not spinning.
Check fans.
Critical Fan Failure
Detected – System
Shutting Down
System Halted
None
A critical fan is not spinning.
1.
Check fans.
2.
Check fan cable
connections.
ECC Multiple Bit Error
Detected in DIMM:
None
A memory module failure
generated a multiple bit error
that could not be corrected.
Run Compaq Diagnostics and
replace failed memory module
as indicated.
FATAL ROM ERROR:
The System ROM is
not properly
programmed
1 long, 1 short
The System ROM is not properly
programmed.
Flash the ROM as explained in
the troubleshooting guide or call
a Compaq authorized service
provider.
Initialization failure.
Re-seat the
processor and
Processor Power
Module before
attempting
replacement
None
Processor was not fully seated.
A processor internal failure
occurred.
1.
Reseat the processor.
2.
Replace the processor if
the failure recurs.
continued