Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 25
Left Side Access Panel
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
2-8 Compaq ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maintenance and Service Guide Left Side Access Panel WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool before touching them. CAUTION: When the server is powered on, the access panels must be installed for proper system cooling. Otherwise, component stress and permanent damage may result. To remove the left side access panel: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Loosen the three side access panel screws on the front of the server. The center screw has no knurling and requires a T-15 screwdriver. 3. Slide the left side access panel back, then pull it away from the chassis. Figure 2-3. Removing the left side access panel Reverse steps 1 through 3 to replace the left side access panel.