Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 76
Remove the Processor board Processor Power Module ninth VRM. See, Power Modules
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Removal and Replacement Procedures 2-59 Processors, Processor Power Modules, Processor Terminator Boards, Processor Board with Tray" earlier in this chapter. 7. Remove the front and rear air baffles. See "Front Air Baffle" and "Rear Air Baffle" earlier in this chapter. 8. Loosen the two processor support brace thumbscrews . Then lift out the processor support brace . 2 1 Figure 2-49. Removing the processor support brace 9. Remove the lower processor support structure. See "Lower Processor Support Structure" earlier in this chapter. 10. Remove the Processor board Processor Power Module (ninth VRM). See "Processor Power Modules" earlier in this chapter.
Removal and Replacement Procedures
2-59
Processors, Processor Power Modules, Processor Terminator Boards, Processor Board
with Tray
”
earlier in this chapter.
7.
Remove the front and rear air baffles. See
“
Front Air Baffle
”
and
“
Rear Air Baffle
”
earlier
in this chapter.
8.
Loosen the two processor support brace thumbscrews
. Then lift out the processor
support brace
.
1
2
Figure 2-49.
Removing the processor support brace
9.
Remove the lower processor support structure. See
“
Lower Processor Support Structure
”
earlier in this chapter.
10.
Remove the Processor board Processor Power Module (ninth VRM). See
“
Processor
Power Modules
”
earlier in this chapter.