Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 79
Integrated Management Display, To remove the Integrated Management Display IMD
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
2-62 Compaq ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maintenance and Service Guide Integrated Management Display To remove the Integrated Management Display (IMD): 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the top access panel. See "Top Access Panel" earlier in this chapter. 3. Disconnect the IMD cable from the I/O board. 4. Press in on the four locking tabs on the rear of the IMD . 5. Pull the IMD from the front of the server . 1 1 1 2 1 Figure 2-53. Removing the IMD Reverse steps 1 through 5 to replace the IMD.
2-62
Compaq ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maintenance and Service Guide
Integrated Management Display
To remove the Integrated Management Display (IMD):
1.
Perform the preparation procedures. See
“
Preparation Procedures
”
earlier in this chapter.
2.
Remove the top access panel. See
“
Top Access Panel
”
earlier in this chapter.
3.
Disconnect the IMD cable from the I/O board.
4.
Press in on the four locking tabs on the rear of the IMD
.
5.
Pull the IMD from the front of the server
.
1
1
2
1
1
Figure 2-53.
Removing the IMD
Reverse steps 1 through 5 to replace the IMD.