Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 92
Expansion Board Guide, Remove the Extended SCSI dividers. See
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Removal and Replacement Procedures 2-75 Expansion Board Guide To remove the expansion board guide: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the top access panel. See "Top Access Panel" earlier in this chapter. 3. Remove any full-length expansion boards from the expansion board slots. See "I/O Expansion Boards" earlier in this chapter. 4. Remove the cables for the fan, speaker, and power switch from the I/O board. 5. Slide the cables through the expansion board guide. 6. Disconnect the Power On/Standby switch cable from the I/O board. 7. Remove the Extended SCSI dividers. See "Extended SCSI Dividers" earlier in this chapter. 8. Press down on the two release grips on the board guide . 9. Push the expansion board guide firmly toward the rear of the unit. Then lift the board out of the server. 2 1 Figure 2-66. Removing the expansion board guide Reverse steps 1 through 9 to replace the expansion board guide.