Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 110

Diagnostics and Troubleshooting 3-13 Table 3-2 POST Error Messages continued Error Code Audible Beeps 40X-Parallel Port X Address Assignment Conflict 2 short 404-Parallel Port Address Conflict Detected 2 short A hardware conflict in your system is keeping some system components from working correctly. If you have recently added new hardware remove it to see if it is the cause of the conflict. Alternatively, use Computer Setup or your operating system to insure that no conflicts exist. 601-Diskette None Controller Error 602-Diskette Boot None Record Error 605-Diskette Drive Type Error 611-Primary Floppy Port Address Assignment Conflict 2 short 2 short Probable Source of Problem Both external and internal ports are assigned to parallel port X. Recommended Action Run the System Configuration Utility and correct. A hardware conflict in your system is preventing the parallel port from working correctly. 1. If you have recently added new hardware, remove it to see if the hardware is the cause of the conflict. 2. Run your System Configuration Utility to reassign resources for the parallel port and manually resolve the resource conflict. 3. Run Compaq Diagnostics to resolve the issue. Diskette controller circuitry failure occurred. The boot sector on the boot disk is corrupt. Mismatch in drive type occurred. A hardware conflict in your system is preventing the diskette drive from operating properly. . 1. Make sure the diskette drive cables are attached. 2. Replace the diskette drive and/or cable. 3. Replace the system board. 1. Remove diskette from the diskette drive. 2. Replace diskette in drive. 3. Reformat diskette. Run the System Configuration Utility to set diskette type correctly. 1. Run your System Configuration Utility to configure the diskette drive port address and manually resolve the conflict. 2. Run Compaq Diagnostics and replace failed assembly as indicated. continued