Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 216

6 Compaq ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maintenance and Service Guide Fail-Safe Timer Expiration 3-81 PCI bus parity error 3-81 processor parity error 3-81 software generated interrupt detected error 3-81 processor exception 3-81 processor prefailure 3-81 required system fan failure 3-81 server manager failure 3-81 UPS A/C line failure shutdown or battery low 3-81 error messages 100MHz memory is incompatible 3-15 A critical error occurred prior to this power-up 3-8 accelerator board not detected 3-45 accelerator error log 3-45 accelerator parity read 3-45 accelerator parity write 3-45 accelerator status cache was automatically configured 3-45 data in the cache was lost 3-45 dirty data detected has reached limit 3-45 dirty data detected. unable to write 3-45 excessive ECC errors 3-46 obsolete data detected 3-46 obsolete data was discarded 3-46 obsolete data was flushed 3-46 possible data loss in cache 3-46 temporarily disabled 3-46 unrecognized status 3-46 valid data found at reset 3-47 warranty alert 3-47 adapter/NVRAM ID mismatch 3-47 array accelerator battery pack X not fully charged 3-47 array accelerator battery pack X below reference voltage 3-47 ASR-2 timer failure 3-9 board in use by expand operation 3-47 board not attached 3-47 bootstrap processor 3-15 cache accelerator slot X initialization failed 3-12 cache accelerators not installed 3-11 com port 2,3, or 4 address conflict detected 3-16 com port address assignment conflict 3-16 configuration nonvolatile memory invalid 3-10 configuration not complete 3-10 configuration signature is zero 3-47 configuration signature mismatch 3-47 configuration/ slot mismatch 3-10 controller communication failure occurred 3-47 detected. NVRAM configuration not present 3-47 firmware needs upgrading 3-47 is not configured 3-48 located in special video slot 3-48 reported POST error 3-48 restarted with a signature of zero 3-48 CPU fan (Fan X) failure detected 3-17 CPU fan controller not responding 3-18 CPU fan not present 3-17 current SCSI bus cable configuration is not recommended 3-18 current system ROM is corrupt 3-9, 3-86 DC-DC converter failed 3-11 disable command issued 3-48 disk 0 configuration error 3-30 disk 0 failure 3-25 disk 1 error 3-30 disk 1 failure 3-25 disk controller failure 3-26 diskette boot record error 3-13 diskette controller error 3-13 diskette drive type error 3-13 drive (bay) X firmware needs upgrading 3-48 has insufficient capacity for its configuration 3-48