Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 217

has invalid M&P stamp 3-48 has loose cable 3-48 is a replacement drive 3-48 is a replacement drive marked OK 3-49 is failed 3-49 is undergoing drive recovery 3-49 needs replacing 3-49 upload code not readable 3-49 was inadvertently replaced 3-49 drive array array accelerator battery charge low 3-31 array accelerator battery depleted 3-30 array accelerator configuration error 3-31 array accelerator not responding 3-31 array accelerator read error 3-31 array accelerator write error 3-31 drive(s) disabled due to array accelerator data loss 3-32 operating in interim rocovery mode 3-28 reports valid data 3-30 resuming automatic data recovery process 3-25 drive monitoring features are unobtainable 3-49 drive monitoring is not enabled 3-49 drive time-out occurred on physical drive bay X 3-49 drive X indicates position Y 3-49 duplicate write memory error 3-49 ECC corrected single bit errors 3-10 error occurred reading RIS copy from SCSI port X 3-50 fan controller not responding 3-18 fan failure detected 3-17 fatal ROM error 3-8 fixed disk 0 does not support DMA mode 3-21 Index 7 fixed disk 1 does not support DMA mode 3-21 fixed disk does not support block mode 3-22 fixed disk failed Identify command 3-21 fixed disk failed set block mode command 3-21 FYI, drive (bay) X is non-Compaq supplied 3-50 I/O fan (Fan X) failure detected 3-17 I/O fan controller not responding 3-18 I/O fan failure detected 3-17 I/O fan not present 3-17 I/O ROM error 3-9 identify controller data did not match NVRAM 3-50 identify logical drive data did not match NVRAM 3-50 insufficient adapter resources 3-50 inter-controller link connection 3-50 internal SCSI jumper board bot installed 3-19 invalid memory configuration 3-10 invalid memory speed 3-11 invalid Voltage Regulator Module 3-11 keyboard controller error 3-12 keyboard error 3-12 keyboard or system unit error 3-12 less than 75% batteries at sufficient voltage 3-50 locked SCSI bus detected 3-18 log reinitialized 3-10 logical drive X failed due to cache error 3-51 logical drive X status Failed 3-51 Interim Recovery 3-51 loose cable detected 3-51 overheated 3-51 overheating 3-52 recovering 3-52 wrong drive replaced 3-52 Loose cable detected, logical drives may be marked failed 3-52 Loose cable detected, logical drives may be marked FAILED 3-52