Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 106
Error Code, Audible Beeps, Probable Source of Problem, Recommended Action, ROMPaq. Refer to the ROMPaq
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Diagnostics and Troubleshooting 3-9 Table 3-2 POST Error Messages continued Error Code Audible Beeps Invalid electronic None serial number No SCSI Devices None Detected Non-System disk None or disk error Parity Check 2 None (RESUME - F1 key) (Run System Configuration Utility - F10 key) Unsupported Processor Detected System Halted None None 1 long, 1 short 101-ROM Error 1 long, 1 short 101-I/O ROM Error None 102-System Board Failure 104-ASR-2 Timer Failure 105-Current System ROM is corrupt - now booting redundant System ROM 162-System Options Not Set None None 2 long 2 short Probable Source of Problem Serial number in BIOS is incorrect. No SCSI devices are connected to the boot controller No bootable disk partition was found on the boot drive A PCI device generated a parity error 2. As indicated to continue. A configuration error occurred during POST Processor not supported by current system ROM. System ROM checksum. Options ROM checksum. 8237 DMA controllers, 8254 timers, and so on. System board failure. Nonbooted ROM image is corrupt. Configuration incorrect. Recommended Action Run the System Configuration Utility to program serial number. Verify configuration. Check SCSI cable, attached drives, and SCSI IDs. 1. Remove diskette from diskette drive. 2. Check controller order in System Configuration Utility. 3. Check boot order in System Configuration Utility. 4. Reinstall operating system. Remove recently added PCI adapters. Re-add the adapters one at a time to determine which is generating errors. Replace the failed device. Press F1. Press F10 to run System Configuration Utility. Check documentation for supported processors, and if supported, remove the processor and update the system to latest ROM. Run Compaq Diagnostics. Replace failed assembly as indicated. Run Compaq Diagnostics. Replace failed assembly as indicated. Replace the system board. Run the System Configuration Utility. Run Compaq Diagnostics. Replace failed assembly as indicated. Flash the ROM utilizing ROMPaq. Refer to the ROMPaq Disaster Recovery section of this guide. Run the System Configuration Utility and correct. continued