Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 78
Then tilt and unhook, Reverse steps 1 through 17 to replace the processor board with tray.
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Removal and Replacement Procedures 2-61 15. Loosen the two thumbscrews securing the processor board with tray to the chassis . 16. Press the lock lever button with a finger or thumb and pull down the processor board handle . 17. Lower the processor board with tray from the back of the chassis . Then tilt and unhook the board from the chassis . 9 10 6 6 7 28 Figure 2-52. Removing the processor board with tray Reverse steps 1 through 17 to replace the processor board with tray. IMPORTANT: If the processor board is not properly seated, the system interlock prevents the system from powering up. Secure the service thumbscrews so the unit will operate properly. See the warning label on the processor board cage for the service screw locations. NOTE: Ensure that all cables are out of the way when reseating the processor board and tray.