Dell Brocade 825 Brocade Adapters Troubleshooting Guide - Page 149
Message, Severity, Event Type, Category, Cause, Action, Base port online: WWN = [Base Port - fc hba driver
View all Dell Brocade 825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
Adapter driver event messages A TABLE 13 Message Driver event messages (continued) Severity Event Type Category Authentication unsuccessful for base Error port: WWN = [base port WWN or MAC]. Network and 2 (Port) storage driver Sub Category Failure Base port enabled: Hardware Information Network and Address = [base port WWN or MAC]. storage driver Base port disabled: Hardware Warning Address = [base port WWN or MAC]. Network and storage driver Base port online: WWN = [Base Port Information Network and WWN]. storage driver Base port offline: WWN = [Base Port Warning WWN]. Network and storage driver Base port (WWN = [base port WWN Error or MAC]) lost fabric connectivity. Network and storage driver 2 (Port) 2 (Port) 2 (Port) 2 (Port) 2 (Port) Enabled Disabled Online Offline Logout Heart Beat of IOC [IOC instance number] is good. Heart Beat of IOC [IOC instance number] has failed. Information Network and 9 (TOC) storage driver Restart Critical Network and 9 (TOC) storage driver Crash IOC [IOC instance number] is enabled. Information Network and 9 (TOC) storage driver Enabled IOC [IOC instance number] is disabled. Warning Network and 9 (TOC) storage driver Disabled New adapter found: SN = [adapter serial number] base port WWN = [Base port WWN]. New SFP found: port [base port number], Hardware Address = [Base port WWN or MAC].. QOS negotiation failed for base port: WWN = base port WWN or MAC]. Information Information Warning Network and storage driver Network and storage driver (stand-up adapters only) Network and storage driver 1 (Adapter) 2 (Port) 2 (Port) Added Found Failure Cause Action Authentication failure. Base port enabled by user command. Base port disabled by user command. Base port logged into fabric. Base port logged out of fabric. Base port lost connection with fabric. Successful restart of firmware after a failure. Firmware not responding. Adapter firmware started by user command. Adapter firmware stopped by user command. Adapter added to host. Mismatch of FC-SP configuration between switch and HBA. Also, check the authentication secret setting. No action required. No action required. No action required. No action required. Check switch and HBA configuration. Also, check SFP and cable connection stand-up adapters. No action required. Collect all error information and restart the firmware. Invoke bfa_supportsave. No action required. No action required. No action required. User plugged in an No action SFP. required. QoS negotiation failed. Check switch and HBA configuration. Brocade Adapters Troubleshooting Guide 125 53-1002145-01