Dell Brocade 825 Brocade Adapters Troubleshooting Guide - Page 159
WWN/MAC, Devine Names, Con Names, Reset, Statistics, Host Name, Setup for Discovery
View all Dell Brocade 825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
HCM and Installer Message Reference B TABLE 14 Message Host Connectivity Manager messages (continued) Cause Corrective Action or Notes The WWN or MAC address already exists in the All WWNs/MACs table. Edit the existing record(s). Record(s) with the same WWN address are highlighted. Occurs when user enters a WWN or MAC address which is already present the WWN/MAC field in the Devine Names dialog box. There are VLANs associated with the port you have selected to be added as a member of the team. If you add the port, all associated VLANS will be removed. Are you sure you want to add this port to the team and remove all associated VLANs? Occurs when the user creates a team with a port for which a VLAN is already configured. Check the same WWN or MAC address is available in the WWNs/MAC view of the Configure Names dialog box. Enter a different WWN or MAC address. Remove the VLAN configured for the port, and then try creating a team with that port. This action resets all listed counters. Do you want to continue? Occurs when the user selects Reset on a Statistics dialog box. Unexpected Error. Test(s) Occurs when the user tries to execute the will be stopped. diagnostics test when the agent is stopped. Unexpected Error. eth Loopback Test will be stopped. Please contact the technical support Occurs when the user executes the loopback test for a port and connection is lost. Unable to find the host. Please provide another host. Occurs when an invalid host name or IP address is given in Host Name field in the Setup for Discovery dialog box. Select Yes to reset all the counter values in the dialog box. Start the agent, and then execute the diagnostics test. Verify the connection, and then proceed with loopback test. Enter a valid host name or IP address in the Host Name field. Unable to extract the driver file {0}. Unable to find the host. Please provide another host. Unable to retrieve the driver update status. Occurs when the driver cannot be extracted. Occurs when link local ipv6 address (such as fe80:216:cbff:fea9:c3b5%en0 or fe80:216:cbff:fea9:c3b5%3) is provided in the Setup for Discovery dialog box. Occurs when the driver update status cannot be retrieved. Provide the IPv6 address without using the scope-id and the delimiter (%). Just use fe80:216:cbff:fea9:c3b5. Information message. Update is not started beyond the timeout value. Closing the driver update operation. Uploading of the driver file is failed. Occurs when the driver update did not start the Information message. timeout value was reached. Occurs when driver file upload failed to Agent Information message. host. Uploading of the driver file is failed. Reason Maintenance mode is not enabled or could not be determined. ESX systems must be in maintenance mode to update drivers. Place system in maintenance mode and reinstall driver(s). Brocade Adapters Troubleshooting Guide 135 53-1002145-01