Dell Brocade 825 Brocade Adapters Troubleshooting Guide - Page 61
VLAN creation and operation problems, devmgmt.msc, Device Manager, Network Adapters, Properties
View all Dell Brocade 825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Network interface problems (CNA or NIC) 2 NOTE For CNAs and Fabric Adapter ports configured in CNA or NIC mode, link speed is always 10 Gbps. You cannot change this parameter. You can view and change these parameters for each port using Windows Device Manager. 1. Run devmgmt.msc to open the Device Manager window. 2. Expand Network Adapters. An instance of the adapter model should display for each installed adapter port. 3. Right-click an the adapter instance that corresponds to the port where you want to change parameters, and select Properties. 4. Select the Advanced tab. 5. Select the property and change the value as appropriate. For more details, refer to the "Adapter Configuration" appendix in the Brocade Adapters Installation and Reference Manual. VLAN creation and operation problems VLAN creation fails with BCU command or HCM or pass-through VLAN stops working after creating with Device Manager. These problems result when VLANs are created using HCM or BCU commands and also using Device Manager. Follow these guidelines to avoid problems: • If you need to create a single VLAN and VLANs have not been created using BCU commands or HCM, you can use Device Manager. • If you want to configure multiple VLANs, disable the port VLAN created in Device Manager (set to 0 value), then configure VLANs using HCM or BCU. Refer to the Brocade Adapters Administrator's Guide for instructions. 1. Symptom: When using BCU commands or HCM, to create VLANs, the initial VLAN fails with an error message. Possible Cause: Port VLAN was created through Device Manager. Action: Set port VLANID to 0 in Device Manager and create VLANs using BCU commands or HCM. 2. Symptom: Passthru VLAN stops working. Possible Cause: Port VLAN was configured through Device Manager. Action: Set port VLANID to 0 in Device Manager. 3. Symptom: Right-clicking on a VLAN device in Device Manager, then selecting Update does not work. Possible Cause: The upgrade option for Brocade 10 Gig Ethernet service is not available. Action: Uninstall and install the service. 4. Symptom: No VLAN operation works except "bcu ethport --vlanlist." Possible Cause: Port VLAN is configured in Device Manager. Action: Set port VLANID to 0 in Device Manager. Brocade Adapters Troubleshooting Guide 37 53-1002145-01