Dell Force10 S4820T S4820T Configuration Guide - Page 103

Figure 6-9. Configuring a Reauthentiction Period FTOS(conf-if-gi-2/1)#dot1x reauthentication interval 7200 FTOS(conf-if-gi-2/1)#dot1x reauth-max 10 FTOS(conf-if-gi-2/1)#do show dot1x interface gigabitethernet 2/1 802.1x information on Gi 2/1: Dot1x Status: Enable Port Control: FORCE_AUTHORIZED Port Auth Status: UNAUTHORIZED Re-Authentication: Enable Untagged VLAN id: None Tx Period: 90 seconds Quiet Period: 120 seconds ReAuth Max: 10 Supplicant Timeout: 30 seconds Server Timeout: 30 seconds Re-Auth Interval: 7200 seconds Max-EAP-Req: 10 Auth Type: SINGLE_HOST Re-authentication Enabled New Maximum New Re-authentication Period Auth PAE State: Backend State: Auth PAE State: Initialize Initialize Initialize Configuring Timeouts If the supplicant or the authentication server is unresponsive, the authenticator terminates the authentication process after 30 seconds by default. This amount of time that the authenticator waits for a response can be configured. To terminate the authentication process due to an unresponsive supplicant: Step 1 Task Command Syntax Terminate the authentication process due to an unresponsive supplicant. dot1x supplicant-timeout seconds Range: 1-300 Default: 30 Command Mode INTERFACE To terminate the authentication process due to an unresponsive authentication server: Step 1 Task Command Syntax Terminate the authentication process due to an unresponsive authentication server. dot1x server-timeout seconds Range: 1-300 Default: 30 Command Mode INTERFACE Figure 6-10 shows configuration information for a port for which the authenticator terminates the authentication process for an unresponsive supplicant or server after 15 seconds. 802.1X | 103