Dell Force10 S4820T S4820T Configuration Guide - Page 705

Configure LSA throttling timers Configured LSA timers replace the standard transmit and acce4patnce times for LSAs. The LSA throttling timers are configured in milliseconds, with the interval time increasing exponentially until a maximum time has been reached. If the maximum time is reached, the system, the system continues to transmit at the max-interval. If the system is stable for twice the maximum interval time, the system reverts to the start-interval timer and the cycle begins again. Command Syntax timers throttle lsa all {start-interval | hold-interval | max-interval} timers throttle lsa arrival arrival-time Command Mode CONFIG-ROUTEROSPF-id CONFIG-ROUTEROSPF-id Usage Specify the interval times for all LSA transmissions • start-interval: Set the minimum interval between initial sending and resending the same LSA. Range: 0-600,000 milliseconds • hold-interval: Set the next interval to send the same LSA. This is the time between sending the same LSA after the start-interval has been attempted. Range: 1-600,000 milliseconds • max-interval: Set the maximum amount of time the system waits before sending the LSA. Range: 1-600,000 milliseconds Specify the interval for LSA acceptance. • arrival-time: Set the interval between receiving the same LSA repeatedly, to allow sufficient time for the system to accept the LSA. Range: 0-600,000 milliseconds Enable passive interfaces A passive interface is one that does not send or receive routing information. Enabling passive interface suppresses routing updates on an interface. Although the passive interface will neither send nor receive routing updates, the network on that interface will still be included in OSPF updates sent via other interfaces. Open Shortest Path First (OSPFv2) | 705