Dell Force10 S4820T S4820T Configuration Guide - Page 660

www.dell.com | support.dell.com FTOS supports three other variations of Spanning Tree, as shown in Table 44. Table 31-1. FTOS Supported Spanning Tree Protocols Dell Force10 Term Spanning Tree Protocol Rapid Spanning Tree Protocol Multiple Spanning Tree Protocol Per-VLAN Spanning Tree Plus IEEE Specification 802.1d 802.1w 802.1s Third Party Implementation Information • The FTOS MSTP implementation is based on IEEE 802.1Q-2003, and interoperates only with bridges that also use this standard implementation. • MSTP is compatible with STP and RSTP. • FTOS supports only one MSTP region. • When you enable MSTP, all ports in Layer 2 mode participate in MSTP. • On the C-Series and S-Series, you can configure 64 MSTIs including the default instance 0 (CIST). Configure Multiple Spanning Tree Protocol Configuring Multiple Spanning Tree is a four-step process: 1. Configure interfaces for Layer 2. See page 946. 2. Place the interfaces in VLANs. 3. Enable Multiple Spanning Tree Protocol. See page 661. 4. Create Multiple Spanning Tree Instances, and map VLANs to them. See page 662. Related Configuration Tasks • Create Multiple Spanning Tree Instances on page 662 • Add and Remove Interfaces on page 661 • Influence MSTP Root Selection on page 663 • Interoperate with Non-FTOS Bridges on page 663 • Modify Global Parameters on page 664 • Modify Interface Parameters on page 665 • Configure an EdgePort on page 666 • Flush MAC Addresses after a Topology Change on page 667 • Debugging and Verifying MSTP Configuration on page 672 660 | Multiple Spanning Tree Protocol (MSTP)