Dell Force10 S4820T S4820T Configuration Guide - Page 226

www.dell.com | support.dell.com You can also use route maps to change this and other BGP attributes. For example, you can include the following command in a route map to specify the next hop address: Command Syntax set next-hop ip-address Command Mode CONFIG-ROUTE-MAP Purpose Sets the next hop address. Change WEIGHT attribute Use the following command in CONFIGURATION ROUTER BGP mode to change the how the WEIGHT attribute is used. Command Syntax neighbor {ip-address | peer-group-name} weight weight Command Mode Purpose CONFIG-ROUTERBGP Assign a weight to the neighbor connection. • weight range: 0 to 65535 • Default is 0 Use the show config command in CONFIGURATION ROUTER BGP mode or the show running-config bgp command in EXEC Privilege mode to view BGP configuration. You can also use route maps to change this and other BGP attributes. For example, you can include the following command in a route map to specify the next hop address: Command Syntax set weight weight Command Mode CONFIG-ROUTE-MAP Purpose Sets weight for the route. • weight range: 0 to 65535 Enable multipath By default, the software allows one path to a destination. You can enable multipath to allow up to 16 parallel paths to a destination. Use the following command in the CONFIGURATION ROUTER BGP mode to allow more than one path. Command Syntax maximum-paths {ebgp | ibgp} number Command Mode Purpose CONFIG-ROUTERBGP Enable multiple parallel paths. • number range: 1 to 16 • Default is 1 The show ip bgp network command includes multipath information for that network. 226 | Border Gateway Protocol IPv4 (BGPv4)