Dell Force10 S4820T S4820T Configuration Guide - Page 132

www.dell.com | support.dell.com FTOS> FTOS>show ip prefix summary Prefix-list with the last deletion/insertion: filter_ospf ip prefix-list filter_in: count: 3, range entries: 3, sequences: 5 - 10 ip prefix-list filter_ospf: count: 4, range entries: 1, sequences: 5 - 10 FTOS> Use a prefix list for route redistribution To pass traffic through a configured prefix list, you must use the prefix list in a route redistribution command. The prefix list is applied to all traffic redistributed into the routing process and the traffic is either forwarded or dropped depending on the criteria and actions specified in the prefix list. To apply a filter to routes in RIP (RIP is supported on C and E-Series.), use either of the following commands in the ROUTER RIP mode: Command Syntax router rip distribute-list prefix-list-name in [interface] distribute-list prefix-list-name out [interface | connected | static | ospf] Command Mode CONFIGURATION CONFIG-ROUTER-RIP CONFIG-ROUTER-RIP Purpose Enter RIP mode Apply a configured prefix list to incoming routes. You can specify an interface. If you enter the name of a nonexistent prefix list, all routes are forwarded. Apply a configured prefix list to outgoing routes. You can specify an interface or type of route. If you enter the name of a non-existent prefix list, all routes are forwarded. To view the configuration, use the show config command in the ROUTER RIP mode as shown in the example below or the show running-config rip command in the EXEC mode. FTOS(conf-router_rip)#show config ! router rip distribute-list prefix juba out network 10.0.0.0 FTOS(conf-router_rip)#router ospf 34 To apply a filter to routes in OSPF, use either of the following commands in the ROUTER OSPF mode: Command Syntax router ospf Command Mode CONFIGURATION Purpose Enter OSPF mode 132 | Access Control Lists (ACLs)