Dell Force10 S4820T S4820T Configuration Guide - Page 444

www.dell.com | support.dell.com • Once the virtual IP address is removed, the system is accessible through the native IP address of the primary RPM's management interface. • Primary and secondary management interface IP and virtual IP must be in the same subnet. Configure Management Interfaces on the S-Series The user can manage the S-Series from any port. Configure an IP address for the port using the ip address command, and enable it using the command no shutdown. The user may use the command description from INTERFACE mode to note that the interface is the management interface. There is no separate management routing table, so the user must configure all routes in the IP routing table (the ip route command). As shown in the following example, from EXEC Privilege mode, display the configuration for a given port by entering the command show interface, and the routing table with the show ip route command. FTOS#show int gig 0/48 GigabitEthernet 0/48 is up, line protocol is up Description: This is the Managment Interface Hardware is Force10Eth, address is 00:01:e8:cc:cc:ce Current address is 00:01:e8:cc:cc:ce Pluggable media not present Interface index is 46449666 Internet address is 10.11.131.240/23 [output omitted] FTOS#show ip route Codes: C - connected, S - static, R - RIP, B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated, O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2, E1 - OSPF external type 1, E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default, > - non-active route, + - summary route Gateway of last resort is 10.11.131.254 to network 0.0.0.0 *S C FTOS# Destination ----------0.0.0.0/0 10.11.130.0/23 Gateway ------via 10.11.131.254, Gi 0/48 Direct, Gi 0/48 Dist/Metric Last Change 1/0 1d2h 0/0 1d2h 444 | Interfaces