Dell Force10 S4820T S4820T Configuration Guide - Page 560

www.dell.com | support.dell.com Save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system for the new settings to take effect. Command Syntax cam-acl { ipv6acl } show cam-acl show cam-acl-egress Command Mode CONFIGURATION EXEC EXEC Privilege Purpose Allocate space for IPV6 ACLs. Enter the CAM profile name followed by the amount to be allotted. When not selecting the default option, you must enter all of the profiles listed and a range for each. The total space allocated must equal 13. The ipv6acl range must be a factor of 2. Show the current CAM settings. Provides information on FP groups allocated for the egress acl. You must allocate at least one group for L2ACL and IPv4 ACL. The total number of groups is 4. Assign an IPv6 Address to an Interface IPv6 Addresses are supported on platforms c e s Essentially IPv6 is enabled in FTOS simply by assigning IPv6 addresses to individual router interfaces. IPv6 and IPv4 can be used together on a system, but be sure to differentiate that usage carefully. Use the ipv6 address command to assign an IPv6 address to an interface. When you configure IPv6 addresses on multiple interfaces (ipv6 address command) and verify the configuration (show ipv6 interfaces command), the same link local (fe80) address is displayed for each IPv6 interface. Command Syntax Command Mode Purpose ipv6 address ipv6 address/mask CONFIG-INTERFACE Enter the IPv6 Address for the device. ipv6 address : x:x:x:x::x mask : prefix length 0 to 128 IPv6 addresses are normally written as eight groups of four hexadecimal digits, where each group is separated by a colon (:). Omitting zeros is accepted as described in Addressing earlier in this chapter. 560 | IPv6 Routing