Dell Force10 S4820T S4820T Configuration Guide - Page 1057

Sample Configurations VRRP for IPv4 Configuration The configuration in Figure 54-20 shows how to enable IPv4 VRRP. This example does not contain comprehensive directions and is intended to provide guidance for only a typical VRRP configuration. You can copy and paste from the example to your CLI. Be sure you make the necessary changes to support your own IP addresses, interfaces, names, etc. Figure 54-20 shows the VRRP topology created with the CLI configuration in Figure 54-22. Figure 54-20. VRRP for IPv4 Topology State Master: R2 was the first interface configured with VRRP Virtual MAC is automatically assigned and is the same on both Routers R2#show vrrp GigabitEthernet 2/31, VRID: 99, Net: 10.1.1.1 State: Master, Priority: 100, Master: 10.1.1.1 (local) Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 661, Gratuitous ARP sent: 1 Virtual MAC address: 00:00:5e:00:01:63 Virtual IP address: 10.1.1.3 Authentication: (none) R2# State Backup: R3 was the second interface configured with VRRP R3#show vrrp GigabitEthernet 3/21, VRID: 99, Net: 10.1.1.1 State: Backup, Priority: 100, Master: 10.1.1.1 (local) Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 331, Bad pkts rcvd: 0, Adv sent: 0, Gratuitous ARP sent: 0 Virtual MAC address: 00:00:5e:00:01:63 Virtual IP address: 10.1.1.3 Authentication: (none) R3# 10.1.1.2 GigE 2/31 10.1.1.1 GigE 3/21 R2 VRID 99 10.1.1.3 R3 Internet Virtual Router Redundancy Protocol (VRRP) | 1057