Dell Force10 S4820T S4820T Configuration Guide - Page 61

Task Command Syntax Command Mode Allow access to INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode. Specify all keywords in the command. Allow access to a CONFIGURATION, INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode command. privilege configure level level {interface | line | route-map | router} {command-keyword ||...|| command-keyword} privilege {configure |interface | line | route-map | router} level level {command ||...|| command} CONFIGURATION CONFIGURATION The configuration in the following example creates privilege level 3. This level: • removes the resequence command from EXEC mode by requiring a minimum of privilege level 4 • moves the command capture bgp-pdu max-buffer-size from EXEC Privilege to EXEC mode by requiring a minimum privilege level 3, which is the configured level for VTY 0 • allows access to CONFIGURATION mode with the banner command • allows access to INTERFACE and LINE modes are allowed with no commands FTOS(conf)#do show run priv ! privilege exec level 3 capture privilege exec level 3 configure privilege exec level 4 resequence privilege exec level 3 capture bgp-pdu privilege exec level 3 capture bgp-pdu max-buffer-size privilege configure level 3 line privilege configure level 3 interface FTOS(conf)#do telnet 10.11.80.201 [telnet output omitted] FTOS#show priv Current privilege level is 3. FTOS#? capture Capture packet configure Configuring from terminal disable Turn off privileged commands enable Turn on privileged commands exit Exit from the EXEC ip Global IP subcommands monitor Monitoring feature mtrace Trace reverse multicast path from destination to source ping Send echo messages quit Exit from the EXEC show Show running system information [output omitted] FTOS#config [output omitted] FTOS(conf)#do show priv Current privilege level is 3. FTOS(conf)#? Management | 61