Dell Force10 S4820T S4820T Configuration Guide - Page 1056

www.dell.com | support.dell.com Figure 54-19. Command Example: show running-config interface FTOS#show running-config interface gigabitethernet 7/30 interface GigabitEthernet 7/30 no ip address ipv6 address 2007::30/64 vrrp-ipv6-group 1 track 2 priority-cost 20 track 3 priority-cost 30 virtual-address 2007::1 virtual-address fe80::1 no shutdown VRRP initialization delay VRRP initialization delay is supported on the and S4820T only. When configured, VRRP is enabled immediately upon system reload or boot. VRRP initialization can be delayed to allow IGP and EGP protocols to be enabled prior to selecting the VRRP Master. This delay ensures that VRRP initializes with no errors or conflicts. The delay can be configured for up to 15 minutes, after which VRRP enables normally. The delay timer is set on individual interfaces and is supported on all physical interfaces, VLANS and LAGs. When both CLIs are configured, the later timer rules the VRRP enabling. For example, if vrrp delay reload 600 and vrrp delay minimum 300, the following behavior occurs: • When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configured for vrrp. • When an interface comes up and becomes operational, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface. Task Command Syntax Set the delay time for VRRP initialization on an individual interface. This is the gap between an interface coming up and being operational, and VRRP enabling. Set the delay time for VRRP initialization on all the interfaces in the system configured for VRRP. This is the gap between system boot up completion and VRRP enabling. vrrp delay minimum seconds Seconds range: 0-900 Default: 0 vrrp delay reload seconds Seconds range: 0-900 Default: 0 Command Mode INTERFACE INTERFACE 1056 | Virtual Router Redundancy Protocol (VRRP)