Dell Force10 S4820T S4820T Configuration Guide - Page 436

www.dell.com | support.dell.com Interface Types Interface Type Physical Management Loopback Null Port Channel VLAN Modes Possible L2, L3 N/A L3 N/A L2, L3 L2, L3 Default Mode Unset N/A L3 N/A L3 L2 Requires Creation No No Yes No Yes Yes (except default) Default State Shutdown (disabled) No Shutdown (enabled) No Shutdown (enabled) Enabled Shutdown (disabled) L2 - No Shutdown (enabled) L3 - Shutdown (disabled) View Basic Interface Information The user has several options for viewing interface status and configuration parameters. The show interfaces command in EXEC mode will list all configurable interfaces on the chassis and has options to display the interface status, IP and MAC addresses, and multiple counters for the amount and type of traffic passing through the interface. If a port channel interface is configured, the show interfaces command can list the interfaces configured in the port channel. Note: To end output from the system, such as the output from the show interfaces command, enter CTRL+C and FTOS will return to the command prompt. Note: The CLI output may be incorrectly displayed as 0 (zero) for the Rx/Tx power values. Perform an SNMP query to obtain the correct power information. The following example displays the configuration and status information for one interface. FTOS#show interfaces tengigabitethernet 1/0 TenGigabitEthernet 1/0 is up, line protocol is up Hardware is Force10Eth, address is 00:01:e8:05:f3:6a Current address is 00:01:e8:05:f3:6a Pluggable media present, XFP type is 10GBASE-LR. Medium is MultiRate, Wavelength is 1310nm XFP receive power reading is -3.7685 Interface index is 67436603 Internet address is 65.113.24.238/28 MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 10000 Mbit, Mode full duplex, Master ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 00:09:54 Queueing strategy: fifo 436 | Interfaces