Dell Force10 S4820T S4820T Configuration Guide - Page 134

www.dell.com | support.dell.com Table 7-3. ACL Resequencing Example (Insert New Rules) seq 7 permit any host 1.1.1.3 seq 10 permit any host 1.1.1.4 Table 7-4. ACL Resequencing Example (Resequenced) seq 5 permit any host 1.1.1.1 seq 10 permit any host 1.1.1.2 seq 15 permit any host 1.1.1.3 seq 20 permit any host 1.1.1.4 Resequencing an ACL or Prefix List Resequencing is available for IPv4 and IPv6 ACLs and prefix lists and MAC ACLs. To resequence an ACL or prefix list use the appropriate command in Table 7-5. You must specify the list name, starting number, and increment when using these commands. Table 7-5. Resequencing ACLs and Prefix Lists List Command IPv4, IPv6, or MAC ACL IPv4 or IPv6 prefix-list resequence access-list {ipv4 | ipv6 | mac} {access-list-name StartingSeqNum Step-to-Increment} resequence prefix-list {ipv4 | ipv6} {prefix-list-name StartingSeqNum Step-to-Increment} Command Mode Exec Exec The following example shows the resequencing of an IPv4 access-list beginning with the number 2 and incrementing by 2. FTOS(config-ext-nacl)# show config ! ip access-list extended test remark 4 XYZ remark 5 this remark corresponds to permit any host 1.1.1.1 seq 5 permit ip any host 1.1.1.1 remark 9 ABC remark 10 this remark corresponds to permit ip any host 1.1.1.2 seq 10 permit ip any host 1.1.1.2 seq 15 permit ip any host 1.1.1.3 seq 20 permit ip any host 1.1.1.4 FTOS# end FTOS# resequence access-list ipv4 test 2 2 FTOS# show running-config acl 134 | Access Control Lists (ACLs)