Dell Force10 S4820T S4820T Configuration Guide - Page 934

www.dell.com | support.dell.com Manage Redundancy on an S-Series Stack Task Command Syntax Reset the current management unit, and make the standby unit the new master unit. A new standby is elected. When the former stack master comes back online, it becomes a member unit. Prevent the stack master from rebooting after a failover. This command does not affect a forced failover, manual reset, or a stack-link disconnect. Display redundancy information. redundancy force-failover stack-unit redundancy disable-auto-reboot stack-unit show redundancy Command Mode EXEC Privilege CONFIGURATION EXEC Privilege Reset a Unit on an S-Series Stack You may reset any stack unit except for the master management unit (Message 2). Message 2 Master Reset Disallowed % Error: Reset of master unit is not allowed. Task Reload a stack-unit Reload a member unit, from the unit itself Reset a stack-unit when the unit is in a problem state. Command Syntax reset stack-unit reset-self reset stack-unit {hard} Command Mode EXEC Privilege EXEC Privilege EXEC Privilege Verifying a Stack Configuration LED Status Indicators on an S4810 or S4820T Stack The light of the LED status indicator on the front panel identifies the unit's role in the stack. For the S4810, the following lists the stacking LED's status indications: Note: On the S4810, the Stacking LED is located on the I/O side of the unit. • Off indicates the unit is a stack member. • Blinking Green indicates the unit is the stack standby. 934 | Stacking