Dell Force10 S4820T S4820T Configuration Guide - Page 700

www.dell.com | support.dell.com Use the no router ospf process-id command syntax in the CONFIGURATION mode to disable OSPF. Use the clear ip ospf process-id command syntax in EXEC Privilege mode to reset the OSPFv2 process. Use the show ip ospf process-id command in EXEC mode (Figure 408) to view the current OSPFv2 status. Figure 33-8. Command Example: show ip ospf process-id FTOS#show ip ospf 55555 Routing Process ospf 55555 with ID 10.10.10.10 Supports only single TOS (TOS0) routes SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Number of area in this router is 0, normal 0 stub 0 nssa 0 FTOS# Enable Multi-Process OSPF Multi-Process OSPF allows multiple OSPFv2 processes on a single router. Follow the same steps as above, when configuring a single OSPF process. Repeat them as often as necessary for the desired number of processes. Once the process is created, all other configurations apply as usual, Step Command Syntax 1 ip address ip-address mask 2 no shutdown Command Mode Usage CONFIG-INTERFACE Assign an IP address to an interface. Format: A.B.C.D/M If using a Loopback interface, refer to Loopback Interfaces on page 446. CONFIG-INTERFACE Enable the interface. Return to CONFIGURATION mode to enable the OSPF process. The OSPF Process ID is the identifying number assigned to the OSPF process, and the Router ID is the IP address associated with the OSPF process. . Command Syntax router ospf process-id [vrf {vrf name}] Command Mode CONFIGURATION Usage Enable the OSPFv2 process globally. Range: 0-65535 vrf name: Enter the VRF key word and instance name to tie the OSPF instance to the VRF. All network commands under this OSPF instance are subsequently tied to the VRF instance. Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot be used again in the system. 700 | Open Shortest Path First (OSPFv2)