Dell Force10 S4820T S4820T Configuration Guide - Page 452

www.dell.com | support.dell.com Reassign an interface to a new port channel An interface can be a member of only one port channel. If the interface is a member of a port channel, you must remove it from the first port channel and then add it to the second port channel. Each time you add or remove a channel member from a port channel, FTOS recalculates the hash algorithm for the port channel. To reassign an interface to a new port channel, use these commands in the following sequence in the INTERFACE mode of a port channel: Step Command Syntax 1 no channel-member interface 2 interface port-channel id number 3 channel-member interface Command Mode INTERFACE PORT-CHANNEL INTERFACE PORT-CHANNEL INTERFACE PORT-CHANNEL Purpose Remove the interface from the first port channel. Change to the second port channel INTERFACE mode. Add the interface to the second port channel. The following text displays an example of moving the GigabitEthernet 1/8 interface from port channel 4 to port channel 3. FTOS(conf-if-portch)#show config ! interface Port-channel 4 no ip address channel-member GigabitEthernet 1/8 no shutdown FTOS(conf-if-portch)#no chann gi 1/8 FTOS(conf-if-portch)#int port 5 FTOS(conf-if-portch)#channel gi 1/8 FTOS(conf-if-portch)#sho conf ! interface Port-channel 5 no ip address channel-member GigabitEthernet 1/8 shutdown FTOS(conf-if-portch)# 452 | Interfaces