Dell Force10 S4820T S4820T Configuration Guide - Page 466

www.dell.com | support.dell.com FTOS(conf-if-gi-3/1)#= Show debounce times in an interface show interface debounce [type] [slot/port] EXEC Privilege Show the debounce time for the specified interface. Enter the interface type keyword followed by the type of interface and slot/port information: • For a 10/100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/ port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10 Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. FTOS# FTOS#show interfaces debounce gigabitethernet 3/1 Interface Time(ms) GigabitEthernet 3/1 200 FTOS# Note: FTOS rounds the entered debounce time up to the nearest hundredth. Note in the example in Assign a debounce time to an interface that the timer was set at 150 ms, but appears as 200 in the example in Show debounce times in an interface above. Disable ports when one only SFM is available (E300 only) Selected ports can be shut down when a single SFM is available on the E300 system. Each port to be shut down must be configured individually. When an E300 system boots up and a single SFM is active this configuration, any ports configured with this feature will be shut down. All other ports are booted up. Similarly, if an SFM fails (or is removed) in an E300 system with two SFM, ports configured with this feature will be shut down. All other ports are treated normally. When a second SFM is installed or replaced, all ports are booted up and treated as normally. This feature does not take affect until a single SFM is active in the E300 system. Disable port on one SFM This feature must be configured for each interface to shut down in the event that an SFM is disabled. Enter the command disable-on-sfm-failure from INTERFACE mode to disable the port when only a single SFM is available. 466 | Interfaces