Dell Force10 S4820T S4820T Configuration Guide - Page 1053

Change that advertisement interval with the following command in the VRRP mode: Task Change the advertisement interval setting. Command Syntax advertise-interval seconds Range: 1-255 seconds Default: 1 second Figure 54-13. Command Example: advertise-interval FTOS(conf-if-gi-1/1)#vrrp-group 111 FTOS(conf-if-gi-1/1-vrid-111)#advertise-interval 10 FTOS(conf-if-gi-1/1-vrid-111)# Command Mode INTERFACE-VRID Figure 54-14. Command Example Display: advertise-interval in VRID mode FTOS(conf-if-gi-1/1-vrid-111)#show conf ! vrrp-group 111 advertise-interval 10 authentication-type simple 7 387a7f2df5969da4 no preempt priority 255 virtual-address 10.10.10.1 virtual-address 10.10.10.2 virtual-address 10.10.10.3 virtual-address 10.10.10.10 FTOS(conf-if-gi-1/1-vrid-111)# Track an Interface or Object Set FTOS to monitor the state of any interface according to the Virtual group. Each VRRP group can track up to 12 interfaces, which may affect the priority of the VRRP group. If the tracked interface goes down, the VRRP group's priority is decreased by a default value of 10 (also known as cost). If the tracked interface's state goes up, the VRRP group's priority is increased by 10. Each VRRP group can track changes in the status of up to 12 interfaces and up to 20 additional objects, which may affect the priority of the VRRP group. If a tracked interface or object goes down, the VRRP group's priority is decreased by a default value of 10 (also known as cost). If the state of a tracked interface or object goes up, the VRRP group's priority is increased by 10. The lowered priority of the VRRP group may trigger an election. As the Master/Backup VRRP routers are selected based on the VRRP group's priority, tracking features ensure that the best VRRP router is the Master for that group. The sum of all the costs of all the tracked interfaces must be less than the configured priority on the VRRP group. If the VRRP group is configured as Owner router (priority 255), tracking for that group is disabled, irrespective of the state of the tracked interfaces. The priority of the owner group always remains at 255. For a virtual group, you can track the line-protocol state or the routing status of any of the following interfaces with the interface interface parameter: • 1-Gigabit Ethernet: Enter gigabitethernet slot/port in the track interface command (see Step 1 below). Virtual Router Redundancy Protocol (VRRP) | 1053