Dell Force10 S4820T S4820T Configuration Guide - Page 44

www.dell.com | support.dell.com 7 not present • display displays additional configuration information. • no-more displays the output all at once rather than one screen at a time. This is similar to the command terminal length except that the no-more option affects the output of the specified command only. • save copies the output to a file for future reference. Note: You can filter a single command output multiple times. The save option should be the last option entered. For example: FTOS# command | grep regular-expression | except regular-expression | grep other-regular-expression | find regular-expression | save Multiple Users in Configuration mode FTOS notifies all users in the event that there are multiple users logged into CONFIGURATION mode. A warning message indicates the username, type of connection (console or vty), and in the case of a vty connection, the IP address of the terminal on which the connection was established. For example: • On the system that telnets into the switch, Message 1 appears: Message 1 Multiple Users in Configuration mode Telnet Message % Warning: The following users are currently configuring the system: User "" on line console0 • On the system that is connected over the console, Message 2 appears: Message 2 Multiple Users in Configuration mode Telnet Message % Warning: User "" on line vty0 "10.11.130.2" is in configuration mode If either of these messages appears, Dell Force10 recommends that you coordinate with the users listed in the message so that you do not unintentionally overwrite each other's configuration changes. 44 | Configuration Fundamentals