Dell Force10 S4820T S4820T Configuration Guide - Page 75

Note: The CONFIGURATION mode lock corresponds to a VTY session, not a user. Therefore, if you configure a lock and then exit CONFIGURATION mode, and another user enters CONFIGURATION mode, when you attempt to re-enter CONFIGURATION mode, you are denied access even though you are the one that configured the lock. Note: If your session times out and you return to EXEC mode, the CONFIGURATION mode lock is unconfigured. Viewing the Configuration Lock Status If you attempt to enter CONFIGURATION mode when another user has locked it, you may view which user has control of CONFIGURATION mode using the command show configuration lock from EXEC Privilege mode. You can then send any user a message using the send command from EXEC Privilege mode. Alternatively you can clear any line using the command clear from EXEC Privilege mode. If you clear a console session, the user is returned to EXEC mode. Recovering from a Forgotten Password on the S4810 or S4820T If you configure authentication for the console and you exit out of EXEC mode or your console session times out, you are prompted for a password to re-enter. If you forget your password: Step 1 2 3 4 5 6 7 Task Command Syntax Command Mode Log onto the system via console. Power-cycle the chassis by switching off all of the power modules and then switching them back on. Hit any key to abort the boot process. You enter uBoot i mme id at ely, as indicated by the => prompt. hit any key (during bootup) Set the system parameters to ignore the startup configuration file when the system reloads. setenv stconfigignore true uBoot To save the changes use the saveenv saveenv command. uBoot Reload the system. reset uBoot Copy startup-config.bak to the running config. copy flash://startup-config.bak running-config EXEC Privilege Management | 75