Dell Force10 S4820T S4820T Configuration Guide - Page 35

IP IPv6 IP COMMUNITY-LIST IP ACCESS-LIST STANDARD ACCESS-LIST EXTENDED ACCESS-LIST LINE AUXILLIARY CONSOLE VIRTUAL TERMINAL MAC ACCESS-LIST MONITOR SESSION MULTIPLE SPANNING TREE Per-VLAN SPANNING TREE PREFIX-LIST RAPID SPANNING TREE REDIRECT ROUTE-MAP ROUTER BGP ROUTER ISIS ROUTER OSPF ROUTER RIP SPANNING TREE TRACE-LIST Note: In the example above, SONET is not supported on the S4810 or S4820T. Navigating CLI Modes The FTOS prompt changes to indicate the CLI mode. Table 2-1, "FTOS Command Modes," in Configuration Fundamentals lists the CLI mode, its prompt, and information on how to access and exit this CLI mode. You must move linearly through the command modes, with the exception of the end command which takes you directly to EXEC Privilege mode; the exit command moves you up one command mode level. Note: Sub-CONFIGURATION modes all have the letters "conf" in the prompt with additional modifiers to identify the mode and slot/port information. These are shown in Table 2-1, "FTOS Command Modes," in Configuration Fundamentals. Table 2-1. FTOS Command Modes CLI Command Mode EXEC Prompt FTOS> Access Command Access the router through the console or Telnet. Configuration Fundamentals | 35