Dell Force10 S4820T S4820T Configuration Guide - Page 617

Figure 29-7. Configuration and Interface mode LLDP Commands R1(conf)#protocol lldp R1(conf-lldp)#? advertise Advertise TLVs disable Disable LLDP protocol globally end Exit from configuration mode exit Exit from LLDP configuration mode hello LLDP hello configuration mode LLDP mode configuration (default = rx and tx) multiplier LLDP multiplier configuration no Negate a command or set its defaults show Show LLDP configuration R1(conf-lldp)#exit R1(conf)#interface gigabitethernet 1/31 R1(conf-if-gi-1/31)#protocol lldp R1(conf-if-gi-1/31-lldp)#? advertise Advertise TLVs disable Disable LLDP protocol on this interface end Exit from configuration mode exit Exit from LLDP configuration mode hello LLDP hello configuration mode LLDP mode configuration (default = rx and tx) multiplier LLDP multiplier configuration no Negate a command or set its defaults show Show LLDP configuration R1(conf-if-gi-1/31-lldp)# Enabling LLDP LLDP is disabled by default. LLDP can be enabled and disabled globally or per interface. If LLDP is enabled globally, all up interfaces send periodic LLDPDUs. To enable LLDP: Step 1 2 Task Enter Protocol LLDP mode. Enable LLDP. Command protocol lldp no disable Command Mode CONFIGURATION or INTERFACE PROTOCOL LLDP Disabling and Undoing LLDP • Disable LLDP globally or for an interface using the command disable. • Undo an LLDP configuration by preceding the relevant command with the keyword no. Link Layer Discovery Protocol (LLDP) | 617